Hiking boots are an essential part of any outdoor enthusiast’s wardrobe. They provide protection from the elements and support for your feet, helping you to get the most out of your adventures.
However, they need to be kept clean in order to maintain their waterproofing capabilities and prevent them from taking on an unpleasant odor. Cleaning the bottom of hiking boots is easy and only requires a few simple steps.
Step 1: Preparing Your Materials
Before you begin cleaning, gather your materials. You will need warm water, a soft cloth or brush, mild detergent, and some newspaper or a towel to protect your work surface. Make sure you have enough paper or towel to cover the entire area where you will be cleaning.
Step 2: Removing Excess Dirt
Start by removing any excess dirt and mud from the bottom of your hiking boots with a soft brush or cloth. Take care not to damage the material by scrubbing too hard. Once all of the dirt has been removed, you can move on to step three.
Step 3: Cleaning With Soap
Mix a small amount of mild detergent with warm water in a container large enough for your boots. Submerge the bottom of each boot in the soapy solution and use a soft brush or cloth to clean away any remaining dirt or stains. Pay extra attention to areas around seams, edges, and stitching where dirt can accumulate.
Step 4: Rinsing & Drying
Rinse each boot thoroughly with clean water until all soap residue is gone. Shake off any excess water then place them on a clean towel or newspaper on top of your work surface.
Allow them time to air dry completely before wearing again.
Conclusion:
Cleaning the bottom of hiking boots is an important part of maintaining them so they last longer and perform better on outdoor trips. By following these four simple steps you can keep your boots looking good as new!
