Merrell hiking boots are a great way to stay dry and comfortable while out on the trail. They provide great protection from the elements, including water.
However, if you’re planning on doing some serious hiking in wet conditions, it’s important to make sure your Merrell boots are waterproof. Fortunately, this process is relatively simple and can be done in just a few steps.
The first step to waterproofing your Merrell boots is to make sure they’re clean. Remove any dirt or debris with a soft brush or cloth and then allow them to air dry completely before applying any additional treatments.
Once your Merrell boots are clean and dry, you can begin the waterproofing process. Apply a generous amount of waterproofing spray or wax to the exterior of the boot. Be sure to cover every inch of the exterior and pay special attention to seams and stitching as these areas are especially prone to moisture penetration.
Next, use a soft brush or cloth to rub the waterproofing into the boot until it’s evenly distributed over the entire surface. Allow it to penetrate for at least 20 minutes before wiping off any excess product.
Finally, use a hairdryer on low heat setting for about 10 minutes to seal in the waterproofing treatment. This will help ensure that your Merrell boots remain water-resistant for longer periods of time.
Conclusion:
Waterproofing Merrell hiking boots is an easy process that can help ensure that you stay dry and comfortable while out on the trail.
All it takes is some cleaning, waterproofing spray or wax, and a few minutes with a hairdryer on low heat setting. Following these steps should help keep your Merrell hiking boots protected from moisture so you can focus on enjoying your adventure!
